Double Power Technology T-708 Manual del operador descargar pdf (Pagina 27)

Setting Up the 708-DS / 709-DS 3

708-DS / 709-DS Operator’s Manual 27

Figure 6 Raising the Stability Feet

3 Using the 90º Allen key in the top of the front level-adjustment

screws, adjust the screws to achieve left-to-right level within

tolerance. It may be necessary to loosen the nut(s) beneath the base

plate to allow for adjustment.

4 Using the 90º Allen key in the top of the rear level-adjustment screw,

adjust the screw to achieve front-to-back level within tolerance. It

may be necessary to lift the heater / circulator to gain access to this

screw.

5 Verify the level of the dissolution apparatus with a bubble or digital

level.

6 Once the unit is leveled, use the open-end wrench to tighten the

nut(s) below the base plate.

7 Lower the side stability feet located toward the back on either side of

the base plate until they touch the laboratory bench. Do not

over-tighten to ensure level is maintained.

8 Reinstall the black caps on all of the screws.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 139 140

Sin comentarios

Double Power Technology T-708 Manual del operador Pagina 27