Double Power Technology T-708 Manual del operador descargar pdf (Pagina 24)

24 708-DS / 709-DS Operator’s Manual

3 Setting Up the 708-DS / 709-DS

Tubing / Cable Connections

Complete the following sections to connect the necessary tubing and

cables for the Agilent 708-DS / 709-DS.

Heater / Circulator Setup (708-DS)

1 Connect the six-pin cable to the rear of the heater / circulator and the

other end into the position marked BATH HEATER on the

dissolution apparatus rear panel.

Figure 3 BATH HEATER Connector

CAUTION

Do not turn on the heater / circulator before filling the water bath to

avoid damaging the internal heating elements of the circulator.

NOTE

The Agilent Wide Input Range Heater / Circulator is pre-installed on the

apparatus at the factory. If reinstallation or replacement is required,

please refer to the Agilent Wide Input Range Heater / Circulator

Operator’s Manual (located on the Technical Documentation CD) for

complete installation instructions.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 139 140

Sin comentarios

Double Power Technology T-708 Manual del operador Pagina 24